Jump to content

Jeep Grand Cherokee N23 Recall


Cushies
 Share

Recommended Posts

If anyone on the forum has or knows someone with a 2005-2010 Jeep Grand Cherokee or Jeep Commander of the same age that has had the N23 Recall done please read on.

I took my Grand Cherokee to Elgin last October for the N23 recall, a software update for a safety issue, see below.

The Final Drive Controller Module (FDCM) software on your vehicle
(VIN: xxxxxxxxxxxxxxxxx) may unintentionally cause the transfer case to shift
into the neutral position without input from the driver. This condition could
allow the vehicle to roll away inadvertently while the vehicle is parked and
cause a crash without warning.

In January this year, on going to select low the warning "service 4x4 system" appeared on the display and low wouldn't engage frown.gif I asked about fearing the worst but was told to have a look on the internet as there had been problems with the N23 recall. After gleaning all the information I could I phoned my Jeep dealer about the problem explaining what I knew, she said Jeep sent out an email regarding this problem and that I should book the vehicle in for a reflash or something similar.
Took a day off work to go to the dealer a two hour round trip where they did the "reflash"

A couple of weeks later on going to engage low the same warning appeared and no low frown.gif in the week after the "reflash" the Jeep had gone in and out of low a few times with no problem.
Another call and another trip to the dealer arranged, this time I was told they could try the procedure three times after which they would have to look at another solution.
Job done and home again.

A few weeks later when in low I went to engage high and "service 4x4 system" appeared again but this time I was stuck in low mad.gif We were out with the dogs so only a couple of miles from home so crawled home at 20mph.
I called the dealer on Monday morning to be told I would have to arrange at my expense a truck to take my Jeep to Elgin mad.gif mad.gif and having no choice I did.
This time they struggled to get it out of low but did manage, they contacted JEEP UK who advised them to check all the electrics wiring etc which they did and all came back clear, I was then told that JEEP UKs techies had said fitting a new actuator WOULD SOLVE THE PROBLEM, initially they said I would be charged for this, I think the part was £340 and labour was £180, I protested this and as a good will gesture they agreed I would pay labour only mad.gif I agreed if this was going to solve the problem, although I told the Service Manager that I couldn't see how changing a part because of what I though was a software issue was going to solve the problem to which he said he could only do what the JEEP UK Techies had advised.
Again the Jeep was booked in and the new parts fitted, but was told the connector plug was corroded inside so they fitted a new one confused.gif confused.gif I thought this would have been one of the first things checked during the electrical and wiring check the did previously, They waived the labour charge for the actuator but I agreed to pay £90 for the new plug. Again I went home hoping that this would be it but wasn't convinced.

A few weeks ago on a trip to the hill I engaged low as there had been flooding with the rain we had making the ground boggy. On leaving the ground at around 8pm I went to engage low when I reached the road "service 4x4 system" and I was stuck in low mad.gif mad.gif mad.gif mad.gif mad.gif mad.gif mad.gif mad.gif mad.gif mad.gif mad.gif mad.gif kill.gif kill.gif kill.gif kill.gif kill.gif kill.gif I called the AA who said because of the weather conditions they would be around five hours to recover me thdown.gif

Again on the Monday morning called the dealer to be told I would have to do all the arrangements to have the vehicle recovered to Elgin cry.gif cry.gif
This time I queried the Service Manager about a software update for this problem to be told they had received a memo which he quickly showed me saying any Jeeps with the noted software should be updated to this new one smile.gif So my Jeep has had the new software installed and thankfully last weekend on a trip to the hill everything worked when I really needed it to worried.gif worried.gif

Almost everytime I'm out I try it in low and so far it's working as it should but I have lost all confidence in the vehicle and have contemplated selling it, this is my fourth Jeep Grand Cherokee and have found them reliable, very capable off road and great value for money, until now where it has been The Jeep network that has been the problem.
I must add that the Elgin Service Manager was 1st class during this time(around seven months) with me being less than polite as this saga wore on.
I don't think I will be replacing this Jeep with another one.

The brothers Jeep is booked in for the fix on Tuesday in Kemnay, and they're telling him porkies already saying they will have to do a diagnostics and probably fit a new actuator, so I've given him the number for the service manager in Elgin biggrin.gif biggrin.gif
Jeep also told me that my vehicle is the only one to have suffered badly, which is absolute bulls**t going by what's on the internet.

For all the people with the vehicles noted at the start,
IF YOU HAVE HAD THE RECALL DONE AND NOT HAD THE REASON TO TRY IT IN LOW PLEASE TRY IT A FEW TIMES BECAUSE IT WILL FAIL AT SOME POINT, and if your none the wiser JEEP will probably try and charge you for the fix.
Edited by Cushies
Link to comment
Share on other sites

Mine was ******** since the reflash too. Spent ages trying to find a solution, but eventually it was simply cured by taking it to a different Jeep dealer and having them reflash it properly.

 

It seems that they need to clear all the codes stored in the system before doing the flash, and possibly to do it repeatedly until it takes. Sounds like a crappy bit of software, but as long as your abs sensors are all working then it should just be a matter of getting the flash done properly.

 

Jeep have been completely hopeless about this all the way through and seem to be unconcerned about keeping customers. I expect they've seen Landrover's success with this type of customer service and product reliability and tried to copy it.

Link to comment
Share on other sites

All sorted,and customer care couldnt have been better with the garage admitting the recall caused the fault.

Took a while for Jeep to sort the problem but cant fault the dealer today,with them valeting and washing the motor afterwards.Only downside was the old fella bought a brand spanking new Grand Cherokee Summit after only going in to give me a lift home.

Link to comment
Share on other sites

  • 7 months later...
I sent this to County Motors in Chelmsford Essex
after my car was recall on the 18/09/2013 for N23 my Low gear selection has never worked it just shows (4WD service due) although I don’t use it often I need you to either reverse the recall or put it right after numerous phone calls you just say its not your fault and it clearly is.
I've been on a forum and Jeep have had a huge amount of customers with this problem and it seems that some dealers deal with it and others don't
and on Facebook jeep seem to admit to the fact that it can happen, it seems a lottery and that’s why they're getting together to issue a law suit against you, I hope you can take this seriously so we can sort it out with out further delay.

on the jeep forum someone had their recall N23 redone on a later edition, updated software and it now works could we try this in the first instance please rather than make a big drama when this may work!
waiting in anticipation
I want to sell my Jeep but 4wd service indicator comes up and people walk away, any help out there

 

Link to comment
Share on other sites

Mine went out originally. Got a re-flash a year or so ago which lasted a while, then it failed again last day of the season. Been re-flashed again and they say it's a new version. So far so good. frustrating though, makes you lose confidence in the car. The biggest problem for me is not the lack of 4 lo as much as when it's not working, the traction control isn't working and that means you can easily get stuck in 4 hi. Stupid situation. When it's working, it's a nice car, but it's definitely a problem child!

Link to comment
Share on other sites

Since I wrote this topic the Jeep has worked faultlessly through the high/low engage.

Eventer1 I would insist they install the new software to correct the faulty software installed for the N23 recall, try giving Jeep UK a caIl 00800 04265337 then press 2 for Customer Relations Enquiries.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...