Jump to content

17hmr for fox????


Phil9
 Share

Recommended Posts

On the right fox, under the right conditions it will drop them like a sack of poop. My use is harvest time Cubs that run right in to the truck, too close to waste a 223 bullet and a bit quieter.

Admittedly I wouldn't have one as my one and only fox gun, at normal lamping ranges (100-200yds) there isn't enough knock down power left and little or no room for error

Link to comment
Share on other sites

If you are consistently ok with the HMR on rabbit headshots at varying ranges and winds then I would say HMR is fine on fox up to around 75 yards (well under 100 anyhow) over that and it becomes a little 'hit or miss' and a slight miss will end up a wounded fox, rather than with Rabbits where the damage is still usually terminal even if not entirely accurate.

Link to comment
Share on other sites

Out to 100 yds, I've not even had one twitch. They go down as dead as a doornail, as the previous replies are saying, be aware of the distance and make sure of the shot placement. Take into account any crosswind, I've been lucky with the weather and taken them on nights when there was little or no wind.

 

Best result ever was three in one evening when my friend's chicken pen was being raided regularly by this little group ;)

Link to comment
Share on other sites

Not a dedicated fox calibre but more then capable of dropping them with correct shot placement. I will head shoot them out to about the 100 yard mark but thats the maximum range. I have only ever shot foxes with the HMR when out after rabbits as I find the .243 gives me a few more options and a lot less walking to get within range.

Link to comment
Share on other sites

fine IMO

you put up a target at 100 yards say 10mm osb board fixed to say 3"X2" CLS backing boards. Now take some shots with an hmr and a 22-250; look at the back your target board and I guarantee you a bullet hole will be through both the board and cls from each round. These `not a suitable rifle` lot are talking rubbish. A sensible shot in the right conditions/range is deadly

Link to comment
Share on other sites

fine IMO

you put up a target at 100 yards say 10mm osb board fixed to say 3"X2" CLS backing boards. Now take some shots with an hmr and a 22-250; look at the back your target board and I guarantee you a bullet hole will be through both the board and cls from each round. These `not a suitable rifle` lot are talking rubbish. A sensible shot in the right conditions/range is deadly

 

The last thing shooters need is for a fox with a large hole in it to limp into someone's garden and then be found by Joe Public.

 

I have shot foxes at 100 yards with my hmr, and would not do so again because one dropped and then ran round until I gave it a 2nd shot. I would choose my 223 every time as there is no messing about - any decent cf has masses of more energy than a hmr to do the job properly at 100 yards or more.

 

Accuracy is only as relevant as the conditions and the shooter behind the gun. I have shot literally dozens of foxes with various calibres of cf, and shot placement is far more 'forgiving' than with an hmr, and there are plenty out there who will always stretch a guns capabilities (and lets ignore the fact that some are hopeless at estimating range).

Link to comment
Share on other sites

This ^. It's not about 'bragging rights', it's about doing a job properly. Then add into the mix the unreliable batches of HMR ammunition, well documented, that give you faster, slower, stuck, squib and wayward rounds every now and again.

 

If you might be a little 'off' better to do so with a calibre that is more forgiving of errors. It's just a matter of ethics, I like my stuff dead as fast and as humanely as possible.

Link to comment
Share on other sites

I simply never understand these type of posts or some responses.

 

Use any calibre within its capabilities and that of the user and ammunition.

 

My HMR drops every fox I pull the trigger on!

 

So does my .22lr, WMR, .223, .243, .308, even the shotgun.

 

:good:

 

post-20848-0-85610600-1461997013_thumb.jpg

These 3 were with .22lr subs.

 

 

post-20848-0-38588100-1461997036_thumb.jpg

These 4 were HMR 17g V-Max

Edited by Dekers
Link to comment
Share on other sites

Myself don,t see a problem with the hmr up to 100yds,its not a centerfire round but if you put it in the right place it will do its job,don,t say i,m a perfect shot but i,ve had runners with a 223 plus 204 and found them next day dead up to 50 - 60 yds away.

Link to comment
Share on other sites

Thank god someone else said it. You also cannot really rely on shot placement with the hmr, too many flyers for my liking.

 

 

Mick, you don't like the HMR, that is pretty obvious from many of your posts. such is life.

 

Fact is I CAN rely on shot placement, I don't get fliers, and the odd hang fire I've had has still resulted in dead quarry with the shot. At the moment I've had squid loads with .22lr, .223 and shotgun, but to date never the HMR.

 

I am fully well aware of the ammo situation and it is far from good, but I have a place for the HMR and it works for me.

 

:yes::good:

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...