Thunderbird Posted December 8, 2011 Report Share Posted December 8, 2011 The handles on the Neff oven in our house have come loose and as far as I can see the only way to access the screws to tighten them is by taking the doors off, then using a Torx screwdriver to take the door to bits to access the screws. Has anyone done this and does anyone know if this is right? Quote Link to comment Share on other sites More sharing options...
AndyCM Posted December 8, 2011 Report Share Posted December 8, 2011 If you check out www.espares.co.uk that may help Quote Link to comment Share on other sites More sharing options...
kent Posted December 8, 2011 Report Share Posted December 8, 2011 phone neff the numbers on the inside of the door on a label/ticket. They will advise off the model number Quote Link to comment Share on other sites More sharing options...
Thunderbird Posted December 9, 2011 Author Report Share Posted December 9, 2011 There's no label or numbers anywhere but I'll check that website out. Thanks. Quote Link to comment Share on other sites More sharing options...
kent Posted December 9, 2011 Report Share Posted December 9, 2011 There's no label or numbers anywhere but I'll check that website out. Thanks. You wouldn't belive the number of models NEFF has sold in the UK tecnical will answer your question but they will need this at least Quote Link to comment Share on other sites More sharing options...
Thunderbird Posted December 9, 2011 Author Report Share Posted December 9, 2011 I'll work it out from pictures online. I've seen an espares video with a slightly different model but I think it's the same principle with all of them. I need to get some Torx screwdriver heads. Cheers. Quote Link to comment Share on other sites More sharing options...
Fisherman Mike Posted December 9, 2011 Report Share Posted December 9, 2011 (edited) The handles on the Neff oven in our house have come loose and as far as I can see the only way to access the screws to tighten them is by taking the doors off, then using a Torx screwdriver to take the door to bits to access the screws. Has anyone done this and does anyone know if this is right? Yes I did about three years ago. However I found that once they had worked loose the Threaded keepers had worn and they became loose again. I did it twice and then ended up replacing the whole oven with a B grade one from that place in Gloucester. It had a scratch on the back ! Assuming its built into the carcass of the kitchen unit housing you might find it easier to knock the power off ( take the fuse out of the Spur above the worktop) remove the oven and work on it out of the housing. Edited December 9, 2011 by Fisherman Mike Quote Link to comment Share on other sites More sharing options...
Thunderbird Posted December 9, 2011 Author Report Share Posted December 9, 2011 Thanks Mike, the doors pop of easily enough so I can do it that way. Can give it a clean at the same time, or someone can... :unsure: There are a few little Torx retaining screws on the bottom of the door and they appear to be the only way of removing that glass 'box' attached to the door. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.