R33SY Posted March 2, 2015 Report Share Posted March 2, 2015 Hi Can any of you knowledgeable gentlemen / ladies tell me me the standard diameter of said hinge pin And also know of where I can get replacements from The chrome has become slightly scratched due the my gun slip and I don't think it will polish out Many thanks R33SY Quote Link to comment Share on other sites More sharing options...
JJsDad Posted March 2, 2015 Report Share Posted March 2, 2015 Not being a Beretta owner, I may be shot down in flames over this comment; but I have always understood the stub pins on these guns screw into the action side walls from the inside. So they cannot be marked up by contact with you gun-slip. The raised circular boss on the outside is integeral to the action and provides greater depth for the blind threaded hole for the stub pin. Quote Link to comment Share on other sites More sharing options...
R33SY Posted March 2, 2015 Author Report Share Posted March 2, 2015 Almost right but not quite , not bad for a non beretta owner though , But the stub pins screw in from the outside only the hex driver is on the inside the raised polished dome is integral to these pins Hence the idea of replacing them with standard size ( if that is what is fitted) Regards R33SY Quote Link to comment Share on other sites More sharing options...
Gunman Posted March 2, 2015 Report Share Posted March 2, 2015 I should buy a new slip if the one you have is doing that sort of damage to the gun . Quote Link to comment Share on other sites More sharing options...
JJsDad Posted March 2, 2015 Report Share Posted March 2, 2015 I stand erected or corrected (whichever); just had a look at a Beretta parts list on the web. Wouldnt have tought you would get to many shops holding them in stock. I call to GMK may sort you out a pair, but they are probably like the other main importers and are trade only, however its probably worth the cost of a phone call to see who the nearest dealer to you is and the trade cost. Quote Link to comment Share on other sites More sharing options...
Catamong Posted March 2, 2015 Report Share Posted March 2, 2015 Try Simpsons of Newmarket, they have a good pedigree with GMK & Beretta's. Cat. Quote Link to comment Share on other sites More sharing options...
welshwarrior Posted March 2, 2015 Report Share Posted March 2, 2015 Send me a PM if your still looking I'll look you out a set. Quote Link to comment Share on other sites More sharing options...
Paolo180 Posted March 3, 2015 Report Share Posted March 3, 2015 Beretta standard hinge pins are 9mm diameter, 1st over size are 9.15mm Quote Link to comment Share on other sites More sharing options...
Hamster Posted March 3, 2015 Report Share Posted March 3, 2015 If they got marked by the gun slip then what's to say the new ones won't ? Quote Link to comment Share on other sites More sharing options...
R33SY Posted March 3, 2015 Author Report Share Posted March 3, 2015 Thanks all for the replies Paolo180 thanks mine measure up at 9.0 mm exactly Welshwarrior. You have a pm Regards R33SY Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.