Jump to content

Menck bushing tool needed.


Seadog1408
 Share

Recommended Posts

The Menck was not actually all that good.

It would slip when being used on stubborn discs..

Most people fabricate something from either a flat bladed turn screw (screw driver) , impact wrench bit (possibly the best)

Pins need to be correctly sized and spaced and breech face may require a little bit of heat , which entails taking the stock off to be safe.

Link to comment
Share on other sites

Check if you need to remove gas vents before trying to remove the discs like on some Spanish guns. 

Bit of gentle heat some penetrating oil and a tap on end of the bit as you try to turn it should free it off. Or impact driver to start it moving. 

Edited by figgy
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...