Jump to content

Bsa ultra- mag retaining probe snapped


youngratter
 Share

Recommended Posts

That retaining probe requires a full strip of the breach block to replace .it passes through  the transfer port. (Holding it in .) Have you stripped an ultra down before. ? 

 

I think there is a small ball bearing holding it in .access from below the breech block 

Im not sure how your gonna get the breech block off with the mag still in it. As acces to the bolt that holds the breech to the airtube .is basically through the mag well . (Just in front actually.)  But the mag needs to be out to get to it. 

Link to comment
Share on other sites

So the small ball bearing and spring go in the yellow hole and retain the pin via the flat section .this also goes along side the brass transfer port .holding that in position .

The orange hole is where the bolt comes through from above and fixes to the air tube section and into the firing valve .

This bolt is only accessible by pushing back the black plastic pellet probe carrier in the mag well (after the pellet probe has been removed ) and the magazine is out . (Thinkbyour in a bit of a catch 22 situation .unless you can get hold of the  broken mag probe and somehow pull it out .or wriggle the mag out and then push the probe out ?? 

IMG_20180515_221137.jpg

I take it you have some of the mag pin in your hand ? Where did it break off ?

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...