county1174 Posted November 19, 2018 Report Share Posted November 19, 2018 Does anyone have a MEC 600 410 shell loader for sale ? Thanks Link to comment Share on other sites More sharing options...
Walker570 Posted November 19, 2018 Report Share Posted November 19, 2018 (edited) I have one but it is not for sale. I purchased the press with a 20gauge set then purchased the 410 kit. I had to have it shipped from the USA as I could not source one here. The USA end would not ship it so I had it sent to a friend over there who shipped it for me. I only use mine for decapping and repriming, then putting in the felt wad, then crimping. The SP3 I use is so fine it escaped all over the place when I tried dropping it and anyway I weigh every load on a scale. I also found that any shot size over 8s tended to hang up in the tube so I weigh those individually as well. Just a bit of useless information which I hope helps you to get where you want to be. If your going to use felt wads then check out Folkestone Engineering. John there has some good recipes as well. Edited November 19, 2018 by Walker570 Link to comment Share on other sites More sharing options...
figgy Posted November 19, 2018 Report Share Posted November 19, 2018 Have a look at fed Kent or clay and game for reloading presses. I use a Lee for sizing and delete prime re prime then a omv mini press. Not sure if Lee do .410. Link to comment Share on other sites More sharing options...
pinfireman Posted November 19, 2018 Report Share Posted November 19, 2018 PM me. I think I have a .410 conversion kit, and a spare MEC 600. Link to comment Share on other sites More sharing options...
Recommended Posts