Jump to content

Miroku scratch repair


Genesius
 Share

Recommended Posts

If its anything like my MK70 (2014  model) its an oil finish but they seem to vary.  On previous occasions I have used ultra fine wire wool and also TCUT to dress down small scratches and then apply a small amount of boiled linseed oil using your finger to finish it.  Use a small amount and rub it until your finger gets hot, and re apply if needed.  

But its a gun and its going to get minor scratches with use, unless its a nasty gouge I wouldn't worry about it!

Link to comment
Share on other sites

I’m not too troubled by the scratches as they are ok the underside of the stock. They are noticeable and repairing them would leave the stock in almost perfect condition. 

 

It’s grade 1, so is there a lacquer available that will match or am I best off to paint in a bit of gloss finish and flat it back as previously suggested?

Edited by Genesius
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...