Jump to content

Beretta A301 help


matgriff
 Share

Recommended Posts

My trusty old Beretta A301 started to jam occasionally recently, so I stripped it down to take a look and give it a good clean.

After I'd cleaned up all the parts, I noticed a small pin lying on my towel, I think it's fell out of the trigger mech block (can't be 100% sure though) but I can't see where it's come from ??

I've looked at the exploded parts diagram in the owners manual and can't see it there either..... any ideas anyone ?

 

Mat

 

 

 

IMG_6215.jpg

Link to comment
Share on other sites

Sorted 🙂

 

Turns out it's a piece of the trigger plate holding pin, that secures the trigger block into the action. Only noticed when I started to re-assemble everything and found out the pin was about 10mm too short... oops

 

New one ordered for the grand sum of £2.50

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...