Jump to content

Which 410 crimp tool?


Dazv
 Share

Recommended Posts

Hi guys I'm after some more advice on reloading 410. Thanks in advance chaps, having everyone's wealth of knowledge on this forum is a godsend to me I really appreciate it! 

Anyway I've been looking into 410 crimp options I've got a loadall set up for 20gauge so that's fine but they don't off a .410 conversion I'm either looking at a roll crimp to go in a drill press or buying one of those crown crimp starters and making a frame for it to go in and make a sliding punch to finish the crimp? I do a large amount of metal work and welding so rigging up a loadall type press won't be tricky but I'm just after your opinions on what I should do???

also open to other options ideally the cheaper the better.

thanks again guys 

Darren 

Link to comment
Share on other sites

Darren

ive been trying to perfect my 410 crimping for a while now

i have a Ponsness warren press with a new crimp starter and a modified press for 3” shells

i would think if you can can get a pre crimp to work use a OMV or Gaep finisher to sort out crimp or just go for rto you should be ok

Link to comment
Share on other sites

i have no crimp start star head, so i have to fold in the petals on a original crimped case and just complete it with the crimper in the link above its adjustable so you can set the depth accurate. it puts a really tight rolledge and uniform fold on previously fold crimp cases, if you got a crimp starter i think it would do just as good a job on new cases.   The GAEP machines and OMV finish fold crimps this way.

A tip on making the tool, dont get the main barrel too big, it just wants to be a snug fit not too much slack, the text in the link is good info, i used a threaded bushing/ insert off ebay. and a bolt drills and drill press, i rto on an old manualy cranked bench drill press, must be over a hundred years old, but i have used it in the typical cheap hobby drill presses with same results.  .

Link to comment
Share on other sites

I use a GAEP spinner from Folkestone Engineering to finish my star crimps but they also do a roll crimp finisher. I run mine on my bench drill with great success and would think the roll utrnover would do the same.  I made a board to mount on the drill pres vice with a hole about 3/16 dep to locate the shells accurately each time.  I lightly smear the top of the shell with wd40... just a smear with the finger helps stop the case spinning and by the time it wants to, it will be done. Takes but a few seconds.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...