Jump to content

Pigeon cradles


invector
 Share

Recommended Posts

Use old fence wire. Not the new high tensile stuff but the stuff pre high tensile, it has a thicker diameter.

High tensile tends to bend too easy when weight is applied.

Its readily available, usually found on his scrap yard. You can make the cradle stem as long as you want. (within reason) to raise you birds above the crop.

 

EF

Link to comment
Share on other sites

i use either fibre glass or bamboo canes then stick the pigeon on it and it hangs and bobs about nicely, and if you want a floater then cut a cane in half put a notch in each end push it through the pigeon just under the wings then hold its wings out using the notches

Edited by hill billy
Link to comment
Share on other sites

 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...