cl06njg Posted July 18, 2016 Report Share Posted July 18, 2016 Hi I have one of the originals but I have no instructions for it. I have phoned and emailed Clive with the usual results. So if any one can email me a set of instructions I would be very grateful. I have been using it but I don't get a very good definition of either cross hairs or the background. But have accounted for three foxes in the last two outings. I am using a good infra-red torch. However I see videos in which the whole picture is much better than mine. As it works fine in the daytime I figure it's probable a set up problem. Also the viper connect Im using is not helping as the add on tends to roll around on the adjustable eye piece!! Cheers Nic Now back shooting after a few years out. Quote Link to comment Share on other sites More sharing options...
Zetter Posted July 18, 2016 Report Share Posted July 18, 2016 A couple of things as I have one of the Ward D 700s which is very similar apart from the camera so this may help 1) I think the Viper connect may be an issue as on all my scopes I have to really wind the dioptre adjustment out a lot to get clear focus on the cross hair. I am short sighted and wear glasses to shoot, normally my dioptre is wound right in for day use but for the Ward it needs to be wound at least two turns out to get the cross hair in focus 2) There should be a little wheel under the bottom of the Ward where the rubber eye cup is. This allows you to focus the unit to your eyes which also will helps on crosshair focus 3) Probably way off base as the viper is parallax adjustable and you have played with this but during the night you need to wind the parallax right down in range to focus the image as IR light has a longer wavelength than visible light so tend to focus much shorter on the parallax usually in the 10 -20 yard range if shooting at say 80 yards Hope this helps Quote Link to comment Share on other sites More sharing options...
cl06njg Posted July 19, 2016 Author Report Share Posted July 19, 2016 Yes that does help I didn't even know that wheel was hiding there! Thanks alot Nic Quote Link to comment Share on other sites More sharing options...
Zetter Posted July 20, 2016 Report Share Posted July 20, 2016 No problems mate glad it helped Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.