sjk88 Posted May 2, 2008 Report Share Posted May 2, 2008 Hi, Had my air rifle a few months now and have noticed recently that the screws holding the trigger guard in place keep working themselves loose. This affects the zero of the scope and I don't want to have to keep tightening them and checking my zero afterwards. It can be quite annoying. Is there anyway to keep them in place apart from using superglue?? Thanks in advance, sjk Quote Link to comment Share on other sites More sharing options...
codling99 Posted May 2, 2008 Report Share Posted May 2, 2008 could use thread lock that should hold them tight,and still can be undone if needed Quote Link to comment Share on other sites More sharing options...
SteveieP Posted May 3, 2008 Report Share Posted May 3, 2008 Add a shakeproof washer. Available at all good DIY stores Quote Link to comment Share on other sites More sharing options...
peter-peter Posted May 3, 2008 Report Share Posted May 3, 2008 Locktite is the answer just a drop on the thread will do it. Quote Link to comment Share on other sites More sharing options...
Browning GTS Posted May 3, 2008 Report Share Posted May 3, 2008 Yes locktite will do the job. well it does on the hammer screws on my old hammergun that used to shoot lose Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.