Pops_Hants

Suppliers are pretty honest with their customers (the shops) who then pass the information on to their customers (us). I imagine most shops will place an order before the increase, it is then up to the shop if they charge the new prices or not. A good example is Barbury shooting ground, they sell all their guns at "old money" or "new money". The gunroom refuses to charge the higher prices when they bought the product pre price increase, in this example it was a CG invictus Probably had around 40k in stock, so not quite "all they had" 🤣

Morning all, Just popped into my local dealer for some cartridges, I’ve been informed that a price increase is due to arrive Feb 1st, on average prices increasing 7%. If you buy in bulk, you may want to get your supply in before Feb 👍🏼

Sold

Still available RFD costs my end are £40.

I'd happily RFD, but it adds a fair amount to an otherwise bargain as you say! 😃

Winchester model 1400 MK II 28” barrel 14” lop 2+1 muktichoke, comes with modified The bolt can be a little sticky when closing but will cycle perfectly. It’s not a big issue but want to be completely honest. £30 located Portsmouth, can meet at most clay grounds in South between Sussex and Dorset

Selling a Hamilton gun slip 47” internal measurement tip to base handle is showing signs of use, everything else in good condition located portsmouth £50

Barbour Cartridge bag Waxed Olive Bought new (but preowned) and in as new condition. It’s never been out of the house, only used it round the house for left over cartridges bag from when I’ve had a handful left from a shoot day. £50 collected, or post at cost Located Portsmouth

Sold

Sold

Thanks, all received. Will get them in the post

Pending

Browning Range Pro Shotgun Slip 136cm Signs of use, but no rips or tears £35 posted to UK mainland

Browning Pro Stock Weights Fits B725 S2 and other models that are cut out on the back to allow the system to be fitted Common fault with these is the top cap snapping off due to excess tightening. Permanent repair made with welding the first weight and top cap together, this means the minimum weight is the 45g threaded rod plus one 20g weight (65g total and small bit of weld). 8x 20g stock weights included, 2 more than normal. £45 posted to UK mainland

Browning Pro Barrel Balance Weights Fits B525 and B725 models £45 posted to Mainland UK postcodes