air gun info needed

[dan222]

Hi all

just got given a SMK 19 airrifle in 22

need some help as to weather it is any good as an air rifle or a cheep bit of scrap ?

also what does the 19 mean

it came with a silencer on it but not a clew of make its held on to the barrel with a grub screw on the taperd end but it still turns round even when the taperd section is fixed tightly with the grub screw to the barrel,

when the scilencer is removed their is a small section with some splines on will try to add photos

can anyone shed some light on these things

hope someone can help cheers ,Dan.

sorry canot seem to upload photos it says 413request entity too large

Edited March 1, 2010 by dan222

[vampire]

Sorry,but you have asked,its scrap.wait and see what others say though cause i have no personal experience of the rifle.But what you want for free

[dan222]

Sorry,but you have asked,its scrap.wait and see what others say though cause i have no personal experience of the rifle.But what you want for free

true thought it be ok for the lad &ratting.

cheers, Dan.

[Clubshot]

Check the following Forum

 

Set up for SMK Users

 

http://ukchineseairgunforum.myfreeforum.or...25fdd56b4261d2a

 

BOB/R

[wuzzy]

the smk xs19 is fine as a hunting or even a plinking rifle i have first handed seen them dispatch vermin at every normal hunting range,the section you mentioned under the silencer is where the open sight was fitted before it was taken off to allow a silencer/cocking aid to be fitted hopoe this helps

[dan222]

the smk xs19 is fine as a hunting or even a plinking rifle i have first handed seen them dispatch vermin at every normal hunting range,the section you mentioned under the silencer is where the open sight was fitted before it was taken off to allow a silencer/cocking aid to be fitted hopoe this helps

thanks for the reply both the front & rearsights are missing/

cheers ,Dan.

[Super Squirrel]

it's an OK target rifle with all stock gear, personally I'd respring it with an Ox trimmed to the correct length to 11.5fpe, bore out the port to 3mm then it'll be fine even for medium range rabbitting. As to scopes, an AGS 4x40 basic would do the trick nicely, as anything more substantial would shake apart. Watch the barrel though, chinese equipment destined for the European market has a tendency to wilt.