Thunderbird Posted July 14, 2011 Report Share Posted July 14, 2011 I've got one of these CO2 pistols and I've noticed recently that the bit of the pistol grip you remove to put in the CO2 refill basically just falls off. It just comes away in my hand but used to 'snap' into position quite nicely when it was new. Any ideas? Quote Link to comment Share on other sites More sharing options...
Fat toad Posted July 14, 2011 Report Share Posted July 14, 2011 Hi mate if the holding clip is hard plastic.over time it can get very smooth and a sheen builds up thus making it useless rough up clip with med/sandpaper .Take care when clean the gun that cleaning products do not enter this area this method works sometime on metal clips to.Do not use these methods if it will spoil the look of the gun on the out side Quote Link to comment Share on other sites More sharing options...
Clubshot Posted July 14, 2011 Report Share Posted July 14, 2011 I have had the S & W CO2 pistols for many years http://ipas.myfreeforum.org/ Always been a pain can bend metal even brought replacement side grip Taped it and tryed Rubber over Grip Design fault - BOB/R Quote Link to comment Share on other sites More sharing options...
Thunderbird Posted July 15, 2011 Author Report Share Posted July 15, 2011 That's a pity, bit of insulating tape then... Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.