merlin66 Posted January 23, 2012 Report Share Posted January 23, 2012 Hi all, Does anyone know how to disable the low beam setting for the Clulite MG125 light?. When i use the pressure switch to turn it on it gives full power which is great but when I release it and press it again it gives me a lower/dimmer output which I find pontless for lamping application. Quote Link to comment Share on other sites More sharing options...
Dr_evil Posted January 23, 2012 Report Share Posted January 23, 2012 If its based on a circuit board then it might be a bit more difficult as that requires moving some diodes about if not and its a simple two stage switch then it should just be a case of slicing the wires that aren't needed Quote Link to comment Share on other sites More sharing options...
steve_b_wales Posted January 23, 2012 Report Share Posted January 23, 2012 I have the above light, and mine has no setting at all for low beam. When I use the pressure switch, the light just goes on or off, with no dimmer setting. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.