Fitting a reverse cam on Isuzu D Max

[pavman]

gents anyone know the best cable route to get the tails into the cab ?

 

I have a number plate cam that looks a fairly easy job to pick up the connections off the rear wire loom in the light cluster but I have to get the connectors to the dash mounted screen into the cab somehow and they have plug terminations so not an easy squeeze...

 

first look round I can see a grommet in the engine bulkhead going to the driver side fuse box but I am thinking it may be best to avoid in case I nick a wire

 

any ideas?

[subsonicnat]

You have a couple of choices really,Head lining,or along the side step covers.

If head lining route down to fuse box,side steps up to fuse box..

If you have to go through bulk head,Grommets are no big deal,No sharps edges then..

[trxnav]

I had the fitted Isuzu one mate they run the cable through the truck along the passenger side under the carpet goes into the cab behind the rear seat in passenger side. I all so installed a cable for lamping mate and for that I used the grommet in the engine bay in the passenger side up behind the glove box but if u look up from the footwell u can see it no need to remove the glovebox at all hope this helps a bit

 

Tab trxnav

[pavman]

I had the fitted Isuzu one mate they run the cable through the truck along the passenger side under the carpet goes into the cab behind the rear seat in passenger side. I all so installed a cable for lamping mate and for that I used the grommet in the engine bay in the passenger side up behind the glove box but if u look up from the footwell u can see it no need to remove the glovebox at all hope this helps a bit

 

Tab trxnav

thanks Guys

 

I found the passenger side one you mention trxnav put a hole in with a screwdriver and pulled it through then sealed with mastic all working fine and I can now see my towbar