Superfox Posted June 28 Report Share Posted June 28 hi guys new to the forum and thanks for letting me join. not very good with all this computer stuff so bear with me. i have an ultra se that is blasting air from the bottom of the magazine slot i replaced probe o ring but still the same. poi has dropped quite alot so must be down on power any ideas would be welcome. regards paul Quote Link to comment Share on other sites More sharing options...
Ultrastu Posted June 28 Report Share Posted June 28 Hi and welcome .sounds a lot like the oring around the valve stem has split . You can see the hammer pin under the magazine - hit the end of the valve stem when you fire (without the magazine in the gun .) There is an oring u can't see around this stem set into the brass firing valve housing. To replace it your going to need to remove the whole valve and use circlip pliers to remove it . These orings don't fail often but can do . I'd order a full o ring kit from Chambers.and replace as many as you can while the gun is apart . Cheers Quote Link to comment Share on other sites More sharing options...
Superfox Posted June 28 Author Report Share Posted June 28 thanks for your reply think ill have to take it someware for a service and new o rings i can do bits but dont fancy full strip .cheers stu regards Paul Quote Link to comment Share on other sites More sharing options...
Superfox Posted June 28 Author Report Share Posted June 28 1 hour ago, Ultrastu said: Hi and welcome .sounds a lot like the oring around the valve stem has split . You can see the hammer pin under the magazine - hit the end of the valve stem when you fire (without the magazine in the gun .) There is an oring u can't see around this stem set into the brass firing valve housing. To replace it your going to need to remove the whole valve and use circlip pliers to remove it . These orings don't fail often but can do . I'd order a full o ring kit from Chambers.and replace as many as you can while the gun is apart . Cheers Quote Link to comment Share on other sites More sharing options...
Ultrastu Posted June 28 Report Share Posted June 28 (edited) Ratworks Phil crampton is good . Edited June 28 by Ultrastu Quote Link to comment Share on other sites More sharing options...
Superfox Posted June 28 Author Report Share Posted June 28 cheers stu looks like a trip to ratworks then this thing is becoming a money pit already put longer air tube and shroud on it hope its worth it .regards paul Quote Link to comment Share on other sites More sharing options...
Superfox Posted June 30 Author Report Share Posted June 30 just wanted to say thanks stu ive stripped gun down and the tiny oring behind the circlip is split in half ordered a kit hope it all goes back together ok. thanks again.regards paul Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.