PotHunter96

I had a look over and couldn’t quite tell if it was a bite Mark on the Back of it’s neck but the feathers were pretty ruffled

Anyone got any tips for using the primos on carrions? When I use it sounds like a fox whistle 😂😂😂

Found a dead mallard duck right at the edge of the water on the stream running through the farm in a little drain, it had 3 or 4 bite marks on its breast and it’s belly partially ripped out is this likely to be a mink?

Thank you will try this

Thank you will give this a try

Ahhh I didn’t, do you mean just with like a rag or?

I let it slam using the release button, I’ve stripped and cleaned it after the last 2 times I’ve been out as it was a bit wet and rainy, could I possibly have over lubed?

I do normally use a side by side but after getting it was just itching to try it out and see how it was

Would just lightly tapping the charging handle do that? forget to say as well it happened the very first time I went to shoot it, other than that it’s been spot on, bet that woodcock thinks it’s good as well haha

Hi all just a quick question, a couple weeks ago I purchased a new hatsan escort extreme and have been very pleased with it, it so far has cycled everything I’ve put through it including my go to woodcock load eley impax, however The other day I had just got over a style so had took the cartridge out of the chamber and then when I was over I opened the bolt dropped it back in and hit the release, not a second later a woodcock flushes from a holly tree but when I went to shoot there was just a click! At the end of the day I tested it and fired it a few times and everything was going through fine, question is if what I’m assuming was the bolt not seating all the way, is this something that can be remedied by just lightly tapping it after I’ve hit the release

Not sure what I’ll make of it to be honest only one way to find out though! Cheers

Not sure if this is right section also forgive the silly question but if I was to try eating woodcock the traditional way am I right in saying I need to remove the gizzard? If so how do I go about doing this?

Are they the blue ar500 plates? Found them on eBay just trying to decide what size to get, don’t want too big but the 2 inch one looks a tad small

Thanks guys, I will check eBay

If I was to make my own gong am I right in saying the thicker the steel the better or would too thick be more likely to cause ricochets