mad1 Posted November 1, 2011 Report Share Posted November 1, 2011 evening all as you might know I am refurbishing my rizzini just to use mainly as a clay gun. I have been rubbing back the barrels as they have quite a lot of pitting on outside :unsure: Question is as I am a sprayer by trade would it be possible to powder them I have all the gear to mask and bung them off but I am concerned about the stoving of them it will take 15 mins at 180c would this affect the barrels at all has any one else got or seen them powdered.....Or shall I just keep on rubbing the marks out and get it blued many thanks m1 Quote Link to comment Share on other sites More sharing options...
samyw Posted November 1, 2011 Report Share Posted November 1, 2011 Yes the heat could cause the top and side ribs to come unsoldered with the in my opinion have them re acid blacked powder coating will chip off quiet easily with a little use hope this helps Quote Link to comment Share on other sites More sharing options...
mad1 Posted November 1, 2011 Author Report Share Posted November 1, 2011 Thanks that was my concern Quote Link to comment Share on other sites More sharing options...
Salopian Posted November 1, 2011 Report Share Posted November 1, 2011 As a car sprayer you could consider spraying them with a two pack acylic?? I saw a gun that had the barrels sprayed metallic, Fern Green it was superb. The attraction to the owner was that it was free! Quote Link to comment Share on other sites More sharing options...
aister Posted November 1, 2011 Report Share Posted November 1, 2011 i had two of my guns powder coated, an old side by side with some pitting and an old pump in the same sort of state, it didnt affect the soldering at all. the coating was fine for an old workhorse type of gun but not something you would do to your prize clay gun Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.