supadonk Posted February 19, 2016 Report Share Posted February 19, 2016 Hi , I have a leak on a pre 06 s410 it is on the male snap connector S470 I am having no success in removing it and I am having difficulty in holding the cylinder whilst trying to undo the 17mm connector any ideas on holding the cylinder without damaging it As it will be stripped, I had just as well replace the cylinder o rings as well RN 234 muchio gracius, the donk . Quote Link to comment Share on other sites More sharing options...
evo Posted February 20, 2016 Report Share Posted February 20, 2016 put a piece of wood either side of your cylinder then put it in a vice you will then be able to remove everything hope this helps Evo Quote Link to comment Share on other sites More sharing options...
Sha Bu Le Posted February 20, 2016 Report Share Posted February 20, 2016 (edited) put a piece of wood either side of your cylinder then put it in a vice you will then be able to remove everything hope this helps Evo Yup Evo has it spot on...........it works, did it with the air cylinder from my HW100. There is a clip on the tube if you would care to have a look. Edited February 20, 2016 by Sha Bu Le Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.