Smiler23 Posted July 26, 2016 Report Share Posted July 26, 2016 Without taking over from the other topic on 10 bore cases, what wadding are you lads using for best performance in cheddite 10 hulls? Cheers Quote Link to comment Share on other sites More sharing options...
TONY R Posted July 26, 2016 Report Share Posted July 26, 2016 Without taking over from the other topic on 10 bore cases, what wadding are you lads using for best performance in cheddite 10 hulls? Cheers Old BPDs about the best for fit the mms and TPSs RSIs etc are a bit sloppy, The PR wads might be worth a try but even though i have a few i dont like how they pattern personaly, my mate swears by them but i am no fan. Good vallue cases the Chedites but wading is a bit of a challenge, im on winchesters at the moment have more than enough for this season and probably next im liking how they are going with versions of my old favourate loads . Quote Link to comment Share on other sites More sharing options...
Smiler23 Posted July 26, 2016 Author Report Share Posted July 26, 2016 Cheers tony r, iv been using the mm in them, and seemed ok, but as always if there's room for improvement.. I'll try it Quote Link to comment Share on other sites More sharing options...
TONY R Posted July 26, 2016 Report Share Posted July 26, 2016 Cheers tony r, iv been using the mm in them, and seemed ok, but as always if there's room for improvement.. I'll try it Thats what its all abbout most things will work but getting it bang on gives you the EDGE i like an EDGE a sharp one very sharp. . Quote Link to comment Share on other sites More sharing options...
Continental Shooter Posted July 30, 2016 Report Share Posted July 30, 2016 American wads are under gauged for EU hulls and this cans caise an array of problems both pressure and safety wise. The gases escaping on the sides of the wad seal can cause long fires as well as throwing the pellets astray. Normally, in the US, special gas seals are sold to avoid this problem, so... be aware Quote Link to comment Share on other sites More sharing options...
TONY R Posted July 30, 2016 Report Share Posted July 30, 2016 One idea i had regarding the wad fit for the chedite hulls, is do what i did with MMs for shooting steel shot in my 8 muzleloader, i used to warm up the wads with a heat gun and i turned up a mandril to push the wad out to make a decent fit in the 8 barrel, it stretched the wad and as such wakened it, but at the muzleloaders low pressures i never had a strike through or a problem, to expand them a little to be a bit better fit in a chedite case would be a lot less of a problem its only slight, you could even try and spread the base seal a little, if you were carefull. TPSs seemed the best fit in the red chedites as i remember this could be the best wad to try for this if anyone fancies messing about to improve things with the chedite cases. Quote Link to comment Share on other sites More sharing options...
Smiler23 Posted August 1, 2016 Author Report Share Posted August 1, 2016 Iv just been looking on that duck hunting forum, there's a topic on there regarding swapping tps wads for mm, a link from bpi puts up a list of data using cheddite cases and tps wads in both 10 and 12 bore, not clever enough to add the link to here sorry Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.