jonesbach Posted November 15, 2010 Report Share Posted November 15, 2010 Hi, looking for a bit of information about the REM 700 action. I have an RWS TITAN 3 and am trying to find some extended weaver bases to fit it, so far to no avail! I have been told by some guys that the action is the same as either the REM 700 or SAUER 200/90. If anyone has a REM 700 and could measure the distance between the two screws that hold the bases on and reply id be grateful. :look: :unsure: Quote Link to comment Share on other sites More sharing options...
garyb Posted November 15, 2010 Report Share Posted November 15, 2010 It's a Sauer 202 based action.. Quote Link to comment Share on other sites More sharing options...
al4x Posted November 15, 2010 Report Share Posted November 15, 2010 can't you get it into a local RFD and get them to fit a few to try, its weird its taking ages to sort out as it worked fine when I last used it. I'd be going up the wall if I had a gun for months and couldn't use it, but then I'm a bit impatient like that Quote Link to comment Share on other sites More sharing options...
jonesbach Posted November 15, 2010 Author Report Share Posted November 15, 2010 cheers gary! do you know if the sauer 202 is the same pre drilled hoes as rem 700? I can use the gun with scopes i purchased with it but have another set to put on but cant until i find an extended base. trouble im having is that my local RFD hasnt even heard of what im looking for!lol! other ive tried are looking around for me but no luck so far. it is getting frustrating though! Quote Link to comment Share on other sites More sharing options...
Gobfish Posted November 15, 2010 Report Share Posted November 15, 2010 I don't know if these figures are any good to you, measuring across the allen key heads of the screws holding my bases on (so dubious on accuracy) there are four screw holes, two fwd and two aft. the fwd pair are 22mm apart (centres) the rear two are 15mm apart (centres) the nearest ones of each pair are 91mm apart. That's as accurate as I can measure them, measured it all several times yet these figures still look odd to me. being an american gun it would be made in imperial but I can't substantiate this . personally I would physically try anything before putting my hand in my pocket Quote Link to comment Share on other sites More sharing options...
jonesbach Posted November 15, 2010 Author Report Share Posted November 15, 2010 Hi gobfish, is this on a rem 700 action? the holes on my RWS are 21.9mm per Ruag so that pretty close to what your measuring at.im not sure why they are so odd either..1? Ive looked into a few ideas but nothing jumping to me yet so hand in pocket is last resort..how deep it goes is still the question! thanks. Quote Link to comment Share on other sites More sharing options...
Gobfish Posted November 15, 2010 Report Share Posted November 15, 2010 Hi gobfish, is this on a rem 700 action? the holes on my RWS are 21.9mm per Ruag so that pretty close to what your measuring at.im not sure why they are so odd either..1? Ive looked into a few ideas but nothing jumping to me yet so hand in pocket is last resort..how deep it goes is still the question! thanks. Yes mate I should have mentioned it is a Remmy 700....... Good luck Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.