20 bore home load crimps

[Floating Chamber]

Hi again after altering press I came out with these what do you think please this is last time I am alter thanks for looking again. will not put this up again as it as been done death.

They will be fine.....enjoy the success with them.

[rbrowning2]

As has been said use them and enjoy them, if later on you want to give them a final touch-up to get a nice round edge then buy

a gaep spinner (£30) from the likes of folkestone engineering supplies.

 

Simple.

[Continental Shooter]

All different sizes and shapes, will pattern differently.

 

Even a few milimiters in the closure might increase or decrease the pressure and result in different patters.

 

My advise: use some sort of stop to get them all at the same height, anything between 59.5 to 59.9 mm should do for more recepies.

 

In general slow burning powder will require a lesser deep crimp and progressive one a deeper crimp.

[Floating Chamber]

All different sizes and shapes, will pattern differently.

 

Even a few milimiters in the closure might increase or decrease the pressure and result in different patters.

 

My advise: use some sort of stop to get them all at the same height, anything between 59.5 to 59.9 mm should do for more recepies.

 

In general slow burning powder will require a lesser deep crimp and progressive one a deeper crimp.

You don't say? (British saying!)

[Continental Shooter]

Yeah, well, it might be obvious but: once you're at it why not trying to do it consistently and to the best possible standard??

 

After all, you're trying to better a factory loads, so, why not doing it in every aspects?