ASunnyD Posted September 2, 2016 Report Share Posted September 2, 2016 This trigger is absolute pants, what can I do? Quote Link to comment Share on other sites More sharing options...
oldypigeonpopper Posted September 2, 2016 Report Share Posted September 2, 2016 hello, This trigger is absolute pants, what can I do? hello, i am sure if that is the case someone has done a video or asked on a forum, google remington thunder jet trigger tune Quote Link to comment Share on other sites More sharing options...
bruno22rf Posted September 2, 2016 Report Share Posted September 2, 2016 As these are imported by SMK I'm guessing that they are a Chinese built Gun very similar to the Express - In which case simply wiz the stock off and take a look at the trigger unit - you should find a small cross headed screw with 3 small washers underneath it - if so just whip 2 of the little fella's out and replace the screw with the remaining washer - Hey Presto - you have a nice trigger p.s. for safety reasons after you have done the above you should cock and load the gun - point it in a safe direction and give her a good shake and bang the stock with the palm of your hand just to make sure the trigger is still safe - 99.9% sure it will be but better safe than sued.. Quote Link to comment Share on other sites More sharing options...
ASunnyD Posted September 2, 2016 Author Report Share Posted September 2, 2016 I like that little disclaimer there haha thanks Bruno and i will see if there's any vids too if I'm having trouble, thanks pigeon popper, good idea I like that little disclaimer there haha thanks Bruno and i will see if there's any vids too if I'm having trouble, thanks pigeon popper, good idea Quote Link to comment Share on other sites More sharing options...
ASunnyD Posted September 2, 2016 Author Report Share Posted September 2, 2016 You both are responsible for a very happy and grateful man-child! Thankyou! I found a site which helps a lot if anybody is experiencing the same issues http://www.instructables.com/id/Break-Barrel-Air-Rifle-Trigger-Fix/ I couldn't find any washers however by removing a spring and adjusting some bits and pieces it is a little heavy still but i only need to pull a fraction to release the sear which feels much better than the 2 inch pull before! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.