Matt S Posted May 17, 2019 Report Share Posted May 17, 2019 Does anyone have a schematic of a lanber field over and under they can share? I need to refit the hammer return block and the cocking can spring. Quote Link to comment Share on other sites More sharing options...
Good shot? Posted May 17, 2019 Report Share Posted May 17, 2019 have you tried T.W. Chambers? Quote Link to comment Share on other sites More sharing options...
Matt S Posted May 17, 2019 Author Report Share Posted May 17, 2019 Had a look at their web site but can't see a diagram or schematic of the lanber action Quote Link to comment Share on other sites More sharing options...
Matt S Posted May 17, 2019 Author Report Share Posted May 17, 2019 No, it's like this https://www.gunpartscorp.com/gun-manufacturer/lanber/lanber-lan But the diagram doesn't tell you where they locate. Fyi they are parts 38 & 39 on the diagram Quote Link to comment Share on other sites More sharing options...
vampire Posted May 17, 2019 Report Share Posted May 17, 2019 Quote Hammer block just lays on its side and will only fit one way. Now the hard bit,if the cocking spring is the 2 little open springs between the cocking blocks,oh boy took me hours to fit them little ………. If you don't get any joy I could send a picture of them in place Quote Link to comment Share on other sites More sharing options...
Matt S Posted May 17, 2019 Author Report Share Posted May 17, 2019 Thanks vampire. Picture would be greatly appreciated. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.