Dodgemball Posted December 12, 2009 Report Share Posted December 12, 2009 I have a Winchester SX3 26" semi auto shotgun with an Easyhit beed fitted to it. My point of impact is a good bit below where my beed is and was wonderering if anyone knew if I can alter the gun in any way so my beed will actually be on my point of impact. I bought the gun from new so do have all the shims if this is anything to do with it? If anyone can help I would be very greatful. Dodgemball Quote Link to comment Share on other sites More sharing options...
sitsinhedges Posted December 12, 2009 Report Share Posted December 12, 2009 Lift your head up to compensate, so your looking down to where the point of impact is. Quote Link to comment Share on other sites More sharing options...
scarecrow243 Posted December 12, 2009 Report Share Posted December 12, 2009 Hi do you mean the point of impact on the ground is below the target ie its closer to you, if yes then this sometimes happens when your bead is a few mm above the barrel, try a target at eye level and note the difference hope this helps Quote Link to comment Share on other sites More sharing options...
BlaserF3 Posted December 12, 2009 Report Share Posted December 12, 2009 Unless you have a master eye problem and need the easyhit remove it and throw it away. Then look at what you are trying to shoot instead of aiming at everything. As long as you can see a little bit of rib and not the back of the receiver all will be well. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.