trickhannah Posted September 17, 2015 Report Share Posted September 17, 2015 hi looking for a pin that fits in just in front of trigger to hold it in mines broke then fell out shooting today thanks Link to comment Share on other sites More sharing options...
matone Posted September 17, 2015 Report Share Posted September 17, 2015 As a temp repair you may be able to get a split roll pin that fits from an engineering workshop. Link to comment Share on other sites More sharing options...
Westley Posted September 18, 2015 Report Share Posted September 18, 2015 I would think that any gunsmiths or gunshop should have them. It is the same pin that fits any of the 300 range of auto's, up to and including the 391 so plenty around. Link to comment Share on other sites More sharing options...
Tony Morris Posted September 19, 2015 Report Share Posted September 19, 2015 I would not think many gunsmiths would keep this pin in stock as it is not a wearing part. It could easily be made using a bit of bar of the correct diameter and length and putting in two grooves for the retaining clips to hold it. The grooves would be easiest machined using a lathe but could be cut using a fairly slow electric drill and a three cornered file. Why did the pin fall out, have the retaining clips failed or been left out when someone has had it apart? If I remember correctly these are 'D' shaped and easily made out of suitable diameter spring wire reshaped and cut to fit. Regards, Tony. Link to comment Share on other sites More sharing options...
Recommended Posts