Jump to content

Kawasaki kr1 250 project


Bigstep
 Share

Recommended Posts

This bike has been rebuilt and has had a lot of time and money on it but I don't have the time to finish it. My plan was to streetfighter it but could be put back to standard as the frame etc has not been altered. I purchased a rear end in good condition and planned to have it painted to match the tank.

The engine has been fully rebuilt and runs and sounds sweet. Frame and parts have been powder coated. Kr1s exhausts with new cans, fuel tap has been rebuilt. I have two sets of calipers and have a full set of seal kits to fit these were £60. Just fitted new chain, Included is a set of digital clocks and loads of spares.

£2600 ono px shotgun

post-32639-0-83337000-1470586331_thumb.jpg

Link to comment
Share on other sites

ooooo Castrol r now that is a smell you never forget ..........................I used to stand behind the start lines at the moto-x meetings just to get the cloud of 2 stroke smoke ...............................those were the days .....and then theres the power band of a good 2 stroke bike

Edited by hodge911
Link to comment
Share on other sites

No mate keeping the tzr

No worries, best of luck with the KR1 sale

 

For those who don't know... the KR1 was, in it's day, a fantastically handling 250 2 stroke, set up properly the rider would struggle to find the bikes limits, and on the circuit was a killer of the 400 4 strokes.

A tidy piece of kit and a lot of fun for the money.

Link to comment
Share on other sites

 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...