CZ Trigger Kit issues

[JohnDeere6630]

i was fitting a rimfire magic trigger kit and even with the heaviest spring the firing pin would occasionally drop when closing the bolt. any one had this problem ?? it works fine now the original spring is back in place

Edited September 10, 2016 by JohnDeere6630

[69chris]

i ended up just using a spacer tube thingy out of the kit and the stock cz spring as all of the rimfire springs 'fired' whilst doing the bump test.

 

thought it was just mine !!!!

[oldypigeonpopper]

hello, i just used the middle spring from kit and works fine, yes a 455

Edited September 11, 2016 by oldypigeonpopper

[Rst1990]

With the kit it says if your using the kit for the cz455 only use the spring and not the tubes.

I don't know what model you have 452/455

[JohnDeere6630]

Its a 452. I've used a tube and the original spring so i have no creep but still a heavy trigger witch is fine as its a hunting rifle

[Rst1990]

Its a 452. I've used a tube and the original spring so i have no creep but still a heavy trigger witch is fine as its a hunting rifle

Try just the spring and no tube.

This shouldn't happen, I just changed the spring on mine as the heavy trigger wasn't best for the field, I used the middle Spring.

The tube reduces creep and the spring lightens the trigger pull, sounds to me as the tube has put the hammer right on the edge and the slightest knock is letting it slip.

I had this with a Cz and took the tube out and put light spring in and all was fine.

[jam1e]

Same here, ditched the tube, middle spring and all is good. And has been for 4 years or so..