jantar Posted May 30 Report Share Posted May 30 Hope someone can assist because my hw100 when operating the sidelever to its full extent will not allow pellet probe back enough to release the magazine. That is after the magazine lock had first been released and using original undamaged Weihrauch magazines. Quote Link to comment Share on other sites More sharing options...
Zoli 12 guage Posted May 30 Report Share Posted May 30 there will,no doubt be some adjustments(s) on the bolt ans/or the sidelever to alter the travel. the information will all be available via whichever search engine you use and/or YouTube. Quote Link to comment Share on other sites More sharing options...
jantar Posted May 30 Author Report Share Posted May 30 Tried that particular search with no results at all. Quote Link to comment Share on other sites More sharing options...
oldypigeonpopper Posted May 30 Report Share Posted May 30 Hello, Give HW 100 Tuning .co.uk an email Quote Link to comment Share on other sites More sharing options...
jantar Posted May 30 Author Report Share Posted May 30 Problem sorted with a quick strip down and access to the hammer assembly by removing the rear cover then cocking the action to allow the hammer to protrude. The side tiny grub screw in the hammer was tight which had not affected the power level BUT the top one at a 45 degree angle had somehow worked loose causing the pellet probe to become loose and able to slide forward enough to block the magazine from entering or leaving unless more pressure was kept on keeping the sidelever fully open. All fine now and as reliable and accurate as it always has been. I hope that repair description helps others who may come across the same problem. Quote Link to comment Share on other sites More sharing options...
Mice! Posted May 31 Report Share Posted May 31 On 30/05/2024 at 08:50, jantar said: Problem sorted with a quick strip down and access to the hammer assembly by removing the rear cover then cocking the action to allow the hammer to protrude. The side tiny grub screw in the hammer was tight which had not affected the power level BUT the top one at a 45 degree angle had somehow worked loose causing the pellet probe to become loose and able to slide forward enough to block the magazine from entering or leaving unless more pressure was kept on keeping the sidelever fully open. All fine now and as reliable and accurate as it always has been. I hope that repair description helps others who may come across the same problem. Sounds clear 👌 glad it's sorted Quote Link to comment Share on other sites More sharing options...
Nublue 22 Posted June 1 Report Share Posted June 1 Have you got a pellet stuck in between the mag and barrel, stick a cleaning rod down and check, might help Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.