lowlander Posted November 30, 2008 Report Share Posted November 30, 2008 i have just pumped my air arms s400 up to 200 bar, but when id finished if i put my ear next to the bit that you fill it up with i could hear air escaping, does this meaan my seals have gone and if so how much will i have to pay to get them replaced :good: Quote Link to comment Share on other sites More sharing options...
snipper Posted November 30, 2008 Report Share Posted November 30, 2008 isnt the max fill pressure 190bar ? seals have gone if the pressure drops alot if left Quote Link to comment Share on other sites More sharing options...
lowlander Posted November 30, 2008 Author Report Share Posted November 30, 2008 in the owners manual it says that the maximum filling pressure is 200bar so i always just filled it to that Quote Link to comment Share on other sites More sharing options...
tweedledee Posted November 30, 2008 Report Share Posted November 30, 2008 is it the old type snap on connector mate,it`s probably just dust not letting the ball come back out under pressure.let her run empty then give it a quick blast of air and it should clear it out. easy fixed i would nt say it`s seals. put some soapy water over it and if it`s bubbling thats the problem.it`s like a ball bearing which closes out under pressure from inside the gun. grit stops it reseating fully Quote Link to comment Share on other sites More sharing options...
lowlander Posted November 30, 2008 Author Report Share Posted November 30, 2008 its the newer version where you have to push it on than twist it so its connected Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.