Jump to content

checking the zero 6.5x55


mubz
 Share

Recommended Posts

Well I when out today just to check the zero of my tikka t3 hunter 6.5x55 and to get a bit more confident with it as its new. Took three shots at 100 yards and grouped less than half an inch :good: so i was very pleased as the last time i did the grouping was not quite as good. Was using fedral power shock 140gr. So feeling confident i set up at 200 yards.... now i was not even on the target! :yes: took another three shots but aimed at least 6 inches above the target and still didnt hit!? it seemed i was hitting the ground just below the bord. Do you think this was me or was it the bullet drop ( it says on the box when zeroed at 100 there should be 4.7inch drop at 200.... conditions were not good, very wet and my scope got a bit unclear...

Link to comment
Share on other sites

i was using a s&b 8x56 with ret 7 i think. I am going to go back and try again because it is most prob me. Im going to try at 150 yards first then at 200. It was the first time shooting at 200yards.. (only had my fac since april)

Link to comment
Share on other sites

i was using a s&b 8x56 with ret 7 i think. I am going to go back and try again because it is most prob me. Im going to try at 150 yards first then at 200. It was the first time shooting at 200yards.. (only had my fac since april)

 

Ahhhh, sounds very like the first time I shot at 200 :good:

 

Try prone with good support, bipod & rolled up jacket works fine, do a couple of dry fires - did the sight picture stay the same ?

 

If you are wobbling, or just not holding crosshairs on target well, stop and recompose + if you know you have pulled a shot then count that out.

 

Breathing, trigger and good technique show up a lot changing from 100 to 200.

 

150 sounds a good bet too :yes:

 

enjoy,

AndyCM

Link to comment
Share on other sites

Ahhhh, sounds very like the first time I shot at 200 :)

 

Try prone with good support, bipod & rolled up jacket works fine, do a couple of dry fires - did the sight picture stay the same ?

 

If you are wobbling, or just not holding crosshairs on target well, stop and recompose + if you know you have pulled a shot then count that out.

 

Breathing, trigger and good technique show up a lot changing from 100 to 200.

 

150 sounds a good bet too :yes:

 

enjoy,

AndyCM

thanks mate for the good advice! :good: i will try at 150 and get confident with that. There was a bit of wobble so i think i just need to work on my breathing etc. Next time i try 200yards i am going to get a larger white bord and see were it it going. All the best. Mo

Link to comment
Share on other sites

I zero my rifles at 200 yards for the very reason that Andy's given. I shoot off a bench where possible using front and rear bags, or off as short a bipod as possible if needs must. A sheet of thick plywood daubed with white paint works wonders for these things.

 

Do bear in mind that the S&B No 7 reticle is quite thick and therefore obscures a fair amount of the target. It's also a fairly low magnification, so it partly masks the extent of any movement. I have shakey hands, and winding up the mag from 7x to 24x gives a more accurate picture of the severity of any wobble.

Link to comment
Share on other sites

Do bear in mind that the S&B No 7 reticle is quite thick and therefore obscures a fair amount of the target.

:good: I went to type out those every words a couple of times but got distracted.

When I had an 8x56 I used to use a target made up out of 4 squares rather than a small circle.

If I can find it, I will post it up here, so you can see what I am on about.

Link to comment
Share on other sites

Have a look at the RWS website http://www.rws-munition.de/en/rifle_cartri...ta.htm?navid=10

 

They do two 6.5 x 55 rounds and my rifle seems to like the 140 grain DK versions, and both are faster/more energy than the Federal round.

 

They also do a zeroing target to print off in A4 size which is quite handy. Even though it can be tricky it really is a good idea to zero when you are not in a rush and the conditions are favourable. Then you will have the confidence in your kit, because you will need it when your heart is pounding, you have your quarry in the sights and the rifle rest isn't perfect.

 

M

Link to comment
Share on other sites

Even though it can be tricky it really is a good idea to zero when you are not in a rush and the conditions are favourable. Then you will have the confidence in your kit, because you will need it when your heart is pounding, you have your quarry in the sights and the rifle rest isn't perfect.

Very good advise - if you have no confidence in your set up, you will never be sure of your shot and things will go downhill :good:

Edited by monkeymagic1969
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...