cole890 Posted September 9, 2009 Report Share Posted September 9, 2009 about 3 weeks ago i bought a brand new cz and have put about 200 rounds through it so far. now the problem is that it doesnt always eject the bullets out of the chamber. it can go for a while without doing it the do it quite regular. is this a common problem? have i done something wrong or is it a case of taking it back?? Quote Link to comment Share on other sites More sharing options...
al4x Posted September 9, 2009 Report Share Posted September 9, 2009 is it pulling the case out of the chamber or not getting that far? Quote Link to comment Share on other sites More sharing options...
George1990 Posted September 9, 2009 Report Share Posted September 9, 2009 Mine often does that (though it always pulls out of the chamber). It pings off the bolt only to fall on top of the magazine rather than fling out. I tried various speeds of pulling the bolt out with empty cases, and it seems to need quite a sharp pull to fling it out. Also seems to be fling out better with a full magazine underneath. Quote Link to comment Share on other sites More sharing options...
scotland rifles Posted September 9, 2009 Report Share Posted September 9, 2009 (edited) clean the chamber ( carfully) do this with a small plastic 17hmr bore brush, but DON'T go to far or you could damage the chamber neck, and both the face of the bolt and the rear of the breach, also clean the extractor claws, i do this after every shoot. HTH bob. Edited September 9, 2009 by scotland rifles Quote Link to comment Share on other sites More sharing options...
stevethevanman Posted September 9, 2009 Report Share Posted September 9, 2009 If you try and cycle the bolt like the sniper out of saving private ryan it helps Also, if you try and give it a little flick when it gets to the end. That helps give the extractor a bit of Oooooooooooomph....thats about my best tips, I dont think its an uncommon problem. If you are really concerned get a gunsmith to check it out. Steve Quote Link to comment Share on other sites More sharing options...
cole890 Posted September 9, 2009 Author Report Share Posted September 9, 2009 its just getting stuck in the chamber you've got to get something to pick the empty shell out of the chamber. cheers chaps i'll take these tips on board and hope it sorts it out. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.