barney 66 Posted February 16, 2014 Report Share Posted February 16, 2014 I am sure this has been asked before but I can't seem to find it, I am after a remote for the nightmaster 800 and X searcher that stays on when you switch it not a momentary switch, does anybody know where I can get one please, Thanks barney Quote Link to comment Share on other sites More sharing options...
V8 90 Posted February 16, 2014 Report Share Posted February 16, 2014 I bought a remote switch from Sikastag on NVUK - it's for a T20 - & then swapped the internals into the end cap of a NM800 it's easy to do & has a latching switch & a moment switch Quote Link to comment Share on other sites More sharing options...
digit Posted February 16, 2014 Report Share Posted February 16, 2014 I cut the pressure switch off mine and put an inline rocker switch on it, a lot easier now Quote Link to comment Share on other sites More sharing options...
barney 66 Posted February 16, 2014 Author Report Share Posted February 16, 2014 Thanks for the replys I will give them some thought, V8 90 the cap you swapped the internals to was it a remote switch anyway ? or did you swap this onto a standard nm800 end cap ? Thanks barney Quote Link to comment Share on other sites More sharing options...
V8 90 Posted February 16, 2014 Report Share Posted February 16, 2014 I put the internals from a T20 cap into the NM cap Quote Link to comment Share on other sites More sharing options...
barney 66 Posted February 16, 2014 Author Report Share Posted February 16, 2014 I put the internals from a T20 cap into the NM cap Ok thanks for that Quote Link to comment Share on other sites More sharing options...
activeviii Posted February 16, 2014 Report Share Posted February 16, 2014 turn torch on and then 1/4 turn of the tail cap to turn off. when you want light just turn the tail cap. less wires and no need to keep hold of the switch while your tracking a wee beastie. Quote Link to comment Share on other sites More sharing options...
wymberley Posted February 17, 2014 Report Share Posted February 17, 2014 (edited) I cut the pressure switch off mine and put an inline rocker switch on it, a lot easier now Many thanks. Bit of a fiddle with the fine wires - found it easier to wipe the cut ends with some solder - but job done. Way to go Barney. Edited February 17, 2014 by wymberley Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.