Rim fire prob

[paulw6969]

Got anshutze .22 had it years but have trouble with magazine one its spot on loads every time but I have two that seem to tilt bullet up and will not load seem to be to high ang thoughts please

[wymberley]

The top of the mag is in 2 sections. If you put a round in you'll see that it is the front of the rear section that grips it. Put another round in one that's OK and this one should lie lower. If it does, then remove both rounds and see if you can notice a difference in the 2 'gapes'. If you can, all well and good, but even if not, it might just pay to gently manipulate the gape so it closes up a little.If it improves things, then gently close it up until the lie of the round when loaded matches the other good mag. However, this last adjustment is best done with the mags fully charged because the compressed follower spring will make a difference.

[The Heron]

I had the same problem it had been caused by me catching the 10 shot magazine on my clothing and that had strained the magazine locating spring in the rifle what I did was to gently pull the spring back into position. I hope this helps you.

[paulw6969]

Thanks you mean nip the gap up what holds the round and it will tilt it forward

[wymberley]

Yep, although I'd say the bullet end tilts down as opposed to up

[paulw6969]

Tried this still will not chamber ,will have to stick with one for now what I have noticed that the one that tilts plastic bit in top is black opposed to red "????

[wymberley]

That's a blow. All mine are red so perhaps that begs a question. All I can now suggest is that you strip the duff ones down and give them a clean. If you haven't done it before, just make sure you've depressed the spring tang fully clear before sliding the bottom plate off.

[Muddy Funker]

I've got an old HW60 that does exactly this, not every time.

Because I'm lazy I just use a finger to line up first round, the next 4 load just fine? I've only got the one magazine.