bishop Posted October 18, 2019 Report Share Posted October 18, 2019 Looking for a 10 bore steel load for csb-0 with tps wads also one using blue dot?? Anyone?Also any lead loads using these???I prefer a RTO but can do a crimp Quote Link to comment Share on other sites More sharing options...
MARSH GUN Posted October 18, 2019 Report Share Posted October 18, 2019 (edited) With CSB0 44x44 44grain under 44 gram in a federal case cx2000 primer and RSI wad . This load was tested at the time i can not remember any more details but did use it extensively. By the way did crimp my loads. Could use this as a starting point for a load with the components you have, with the caveat of getting it tested. Blue dot and steel loads do exist but i dont use them, but in lead from memory i used 42 grain card seal felt wrapper buffer and 2 1/8 oz, give you something to start with. Edited October 18, 2019 by MARSH GUN Quote Link to comment Share on other sites More sharing options...
shakin stevens Posted October 18, 2019 Report Share Posted October 18, 2019 I know when csb0 was out clay and game sold it , and have the data to go with it . They had steel and lead data for csb0 in all gauges , £1 a sheet through paypal off their website as I remember. Quote Link to comment Share on other sites More sharing options...
Sundodger Posted October 24, 2019 Report Share Posted October 24, 2019 Hello Bishop. Ballistic Products do a book for reloading 10g The Mighty 10 Gauge it has al the information you need for reloading with proven recipes. all the best Quote Link to comment Share on other sites More sharing options...
bishop Posted October 24, 2019 Author Report Share Posted October 24, 2019 thanks for that.I have a few more now than i did before.Its all good. Quote Link to comment Share on other sites More sharing options...
greylag1 Posted October 27, 2019 Report Share Posted October 27, 2019 if you use tps wads don't go 44 grain the pressure is high,i used 46gr with a sam1 wad but dropped to 42gr with a tps Quote Link to comment Share on other sites More sharing options...
bishop Posted October 27, 2019 Author Report Share Posted October 27, 2019 46 minutes ago, greylag1 said: if you use tps wads don't go 44 grain the pressure is high,i used 46gr with a sam1 wad but dropped to 42gr with a tps Aye i have em loaded with 42 grains.Someone else said the same. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.