manton Posted November 30, 2023 Report Share Posted November 30, 2023 Any heating engineers here. The circulating pump on my fairly old oil heating system died and when I replaced it I noticed that although it was in the returm pipe it was pumping away from the boiler. Surely this cannot be correct What would happen if I turned it round to pump into the boiler. Could it aause any calamities somewhere else in the system? . Quote Link to comment Share on other sites More sharing options...
serrac Posted December 1, 2023 Report Share Posted December 1, 2023 Assuming the previous pump was pointing in the same direction and the heating was working OK, you may as well leave as is. If you have thermostatic valves on your radiators they may rattle at times if the flow is in the opposite direction to what was expected when they were installed. Also, if it's an open system with a header tank in the loft you may find the pump pushes water into the header tank rather than round the system as the pressure differential has reversed. Quote Link to comment Share on other sites More sharing options...
old'un Posted December 1, 2023 Report Share Posted December 1, 2023 sounds like an open vented system as it as an external pump, ours is an open system and the pump is fitted to the boiler hot water out and pumps hot water around the rads and hot water tank. Must admit the way yours is working does sound odd. Quote Link to comment Share on other sites More sharing options...
manton Posted December 1, 2023 Author Report Share Posted December 1, 2023 (edited) 3 hours ago, serrac said: Assuming the previous pump was pointing in the same direction and the heating was working OK, you may as well leave as is. If you have thermostatic valves on your radiators they may rattle at times if the flow is in the opposite direction to what was expected when they were installed. Also, if it's an open system with a header tank in the loft you may find the pump pushes water into the header tank rather than round the system as the pressure differential has reversed. Thank you for your reply which I found most informative. The last paragraph might point toward an answer to what is happening, . I have a noise like running water in the loft and a new radiator I fitted is stone cold The previous owner of the house said they had always had problems with that radiator. Is it possible that the pressure of the pump is being wasted Edited December 1, 2023 by manton Spelling Quote Link to comment Share on other sites More sharing options...
serrac Posted December 2, 2023 Report Share Posted December 2, 2023 On 01/12/2023 at 10:50, manton said: Thank you for your reply which I found most informative. The last paragraph might point toward an answer to what is happening, . I have a noise like running water in the loft and a new radiator I fitted is stone cold The previous owner of the house said they had always had problems with that radiator. Is it possible that the pressure of the pump is being wasted You could try turning the pump round to try it in the other direction - there's normally valves on either side of it so you don't need to drain the system. I'm sure you're aware of that since you fitted a new pump 🙂 The radiator not heating up sounds like an airlock in the system preventing hot water flowing through that one. They can be a pig to get rid off because of course you can't see where they are hiding. There's various videos in YouTube how to deal with them but the basic idea is to force water through the system expelling any air pockets. Make sure your system has inhibitor in it as corrosion inside the radiators or boiler creates gas which can eventually form another airlock. Quote Link to comment Share on other sites More sharing options...
Old Boggy Posted December 2, 2023 Report Share Posted December 2, 2023 2 hours ago, serrac said: You could try turning the pump round to try it in the other direction - there's normally valves on either side of it so you don't need to drain the system. I'm sure you're aware of that since you fitted a new pump 🙂 The radiator not heating up sounds like an airlock in the system preventing hot water flowing through that one. They can be a pig to get rid off because of course you can't see where they are hiding. There's various videos in YouTube how to deal with them but the basic idea is to force water through the system expelling any air pockets. Make sure your system has inhibitor in it as corrosion inside the radiators or boiler creates gas which can eventually form another airlock. The lack of inhibitor as said, can cause `Hydrogen Evolution` put simply is the oxidation of copper (pipework) or steel (radiators) taking out the oxygen to leave pure hydrogen. This is often mistaken for air in the system normally on the highest radiator but can determined by bleeding the radiator and applying a naked flame at the bleed point. If hydrogen this will give a small blue flame a bit like a tiny blow lamp. It also sounds as if the pump being reversed is now pumping over the vent, hence the `rushing` sound. It very much depends on the position of where the cold feed is connected to the system, known as `The Neutral Point`. I would be inclined, as serrac says, to try turning the pump round. OB Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.