verminer Posted June 4, 2008 Report Share Posted June 4, 2008 hi all, i have just aquired a webley 410 single shot bolt action 2-1/2 inch shotgun, i cannot find any type of safety catch on it so i assume that it does not have one, am i correct. thanks for your advice. Quote Link to comment Share on other sites More sharing options...
highseas Posted June 4, 2008 Report Share Posted June 4, 2008 its on the back of the bolt the bit you can pull back to cock it well it will turn about a 4/1 turn in to a notch that says safe on it does that make sence? Quote Link to comment Share on other sites More sharing options...
mattslaptop247 Posted June 4, 2008 Report Share Posted June 4, 2008 Thats right, I had one of these. If you pull the bolt back and take the rear theres a round kno, get hold of this and pull it back further, it should extend then you give it a quarterturn clock wise and let go, it will lock into place. Sound loads more complicated than it is lol Quote Link to comment Share on other sites More sharing options...
webber Posted June 4, 2008 Report Share Posted June 4, 2008 I have a Webley & Scot 9mm bolt action thats the same, 1/4 turn, quite neat really. webber Quote Link to comment Share on other sites More sharing options...
Zapp Posted June 4, 2008 Report Share Posted June 4, 2008 I seem to recall that some very early models have no safety at all . Unless it is one of these, it should be where the chaps above have stated. ZB Quote Link to comment Share on other sites More sharing options...
thomasbeaton Posted June 4, 2008 Report Share Posted June 4, 2008 when cocked pull the bolt back and turn it right about quarter turn in to a little slop and SAFTY should appear on the end of the bolt, hope this helps. thomas Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.