30-6 Posted June 25, 2018 Report Share Posted June 25, 2018 Is it correct that a jimny headlight lens is made of polycarbonate and if " clouded " over can be cleaned using a light buff with T- cut ? Quote Link to comment Share on other sites More sharing options...
dead eye alan Posted June 26, 2018 Report Share Posted June 26, 2018 13 hours ago, 30-6 said: Is it correct that a jimny headlight lens is made of polycarbonate and if " clouded " over can be cleaned using a light buff with T- cut ? Dont laugh but try tooth paste it works great. Quote Link to comment Share on other sites More sharing options...
Dunkield Posted June 26, 2018 Report Share Posted June 26, 2018 There was a thread on this not so long ago. You can do as Dougy says or buy a kit from ebay Quote Link to comment Share on other sites More sharing options...
rovercoupe Posted June 27, 2018 Report Share Posted June 27, 2018 Went through this a couple of months ago with some headlights so bad the outer layer of uv protection was cracking and chipping off, bought the phillips kit which was not cheap but seemed the best. Took a couple of hours but they look like new now. Beam pattern is far better and it seems much brighter now. they key is to have a good uv treatment once cleaned off as they will fog up in double quick time if left un protected. buy some full sheets of wet and dry if there bad it makes life alot easier than the crappy little bits in any kit, i ignored the advice and did it wet through all grades given the amount of **** that needed to come off. Quote Link to comment Share on other sites More sharing options...
DrBob1 Posted June 28, 2018 Report Share Posted June 28, 2018 I used the T-cut headlight kit on my Jimny (though I'm pretty sure the lenses are glass on mine) it removed all the fogging with minimal effort. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.