Cloudhopper Posted January 16, 2021 Report Share Posted January 16, 2021 Hi, I joined the forum last year when I started clay shooting again and have found the forum to have many knowledge members, with this in mind I have a question reference my Beretta 686 30” sporter which I bought new in 1987. It has been lightly used with less than 10,000 cartridges going through it, and has always been cleaned and oiled after use. The other day l took off the stock and removed the trigger assembly from the action to gain access to the top lever screw which had come loose. After resecuring the top lever screw with low strength loctite I had a good look around and noticed a groove in the right hand ( bottom barrel) cocking rod channel, caused by the fore-end iron R/H lever by the looks of it, has anybody else seen this? Photo attached I’m located just west of Aberdeen and just started clay shooting again in the summer,I’m aware of the gun shop/ dealers near me but not a gunsmith,any recommendation would be appreciated Hope you can help cloudhopper Quote Link to comment Share on other sites More sharing options...
Rob85 Posted January 16, 2021 Report Share Posted January 16, 2021 Looks like that has been done as the gun closed, the metal being pusjed forward. could something have fallen into the open action and got dragged as it was closed? Quote Link to comment Share on other sites More sharing options...
Cloudhopper Posted January 16, 2021 Author Report Share Posted January 16, 2021 The cocking rod is fully rearward as I was able to operate the spring loaded cocking levers from the rear of the action, normally they are full forward and the grooved area is hidden, The contact point on the fore-iron lever is not polished like the other side, but matt and not as smooth to the touch. Quote Link to comment Share on other sites More sharing options...
Cawdor118 Posted January 16, 2021 Report Share Posted January 16, 2021 My 686 has a similar issue where the two lugs engage with the barrel. The barrel holes are elongated... It doesn't bother me but does look ****. Dont worry about it, the material is obviously soft but doesn't detriment operation. Quote Link to comment Share on other sites More sharing options...
figgy Posted January 18, 2021 Report Share Posted January 18, 2021 Might be best sending your gun to a recommended gunsmith for a service and once over to see if can be sorted. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.