aberisle Posted January 29, 2021 Report Share Posted January 29, 2021 (edited) During this current lockdown period i have been playing around with my 3d printer. I have made some wad and case trimmers there are two versions the yellow onw will trim 12 bore wads and 20 cases the red version will trim 12 and 10 bore cases along with 10 bore wads, i had some wads that were pre split and these were a pain in the neck trying to trim them but i found that if i used a section of and old case this would hold the split wad together and allowed me to cut it down quite easily. I have just started using TSS and the wads need to be cut down for this and the wad trimmer makes it easy to get accurate and repeatable cuts. If any one is interested in buying one they are £12 each posted. With the cutter you get 3 blades and two different length of screws to allow a wide range of case and wad lengths to be trimmed. Edited January 29, 2021 by aberisle Link to comment Share on other sites More sharing options...
mellors Posted January 29, 2021 Report Share Posted January 29, 2021 Very useful bit of kit. Well done. Link to comment Share on other sites More sharing options...
Vince Green Posted January 29, 2021 Report Share Posted January 29, 2021 very good Link to comment Share on other sites More sharing options...
Dogs Posted January 29, 2021 Report Share Posted January 29, 2021 Nice one ! Any thoughts on doing a 16 bore version ? Link to comment Share on other sites More sharing options...
aberisle Posted January 29, 2021 Author Report Share Posted January 29, 2021 39 minutes ago, Dogs said: Nice one ! Any thoughts on doing a 16 bore version ? There is just over 1.5 mm difference between the 16 and 20 bore cartridge the yellow 20 bore one should be able to do 16 bore as well, i can do both 12 and 10 bore on the larger red one. Link to comment Share on other sites More sharing options...
Dogs Posted January 29, 2021 Report Share Posted January 29, 2021 Would I be right in thinking it would trim plastic 16 bore wads also ? Link to comment Share on other sites More sharing options...
aberisle Posted January 29, 2021 Author Report Share Posted January 29, 2021 (edited) Its a bit too large in diameter for a 16 bore wad but if you wanted one it would be no problem to print one off for you, the price would be the same. edit : i have put one on to print just now i will check it in the morning with a 16 bore wad and let you know Edited January 29, 2021 by aberisle Link to comment Share on other sites More sharing options...
Dogs Posted January 29, 2021 Report Share Posted January 29, 2021 Ok bud , Link to comment Share on other sites More sharing options...
aberisle Posted January 30, 2021 Author Report Share Posted January 30, 2021 The 16 bore trimmer works fine , let me know if you want one. thanks...james Link to comment Share on other sites More sharing options...
Joe Manton Posted December 17, 2024 Report Share Posted December 17, 2024 I have only just discovered this post, good work. Please can you tell me if you still have these available, I am looking at the red version will trim 12 and 10 bore cases ? Link to comment Share on other sites More sharing options...
welsh1 Posted December 17, 2024 Report Share Posted December 17, 2024 Links to other sites are not allowed. Link to comment Share on other sites More sharing options...
aberisle Posted December 17, 2024 Author Report Share Posted December 17, 2024 14 minutes ago, welsh1 said: Links to other sites are not allowed. Ok i have taken the link down if any one wants one just PM me Link to comment Share on other sites More sharing options...
Recommended Posts