Jump to content

Relacement Magazine.


Recommended Posts

I recently purchased a replacement / spare mag for my Daystate Regal . Its a 3Dprinted item from Element Objects .

I followed the instructions , tried the 'Stop pin' in the holes provided , but the pellet probe would not go through the mag, even if I 

'Floated' the mag to try and centralise it.  It was quite expensive . So will contact the gun shop i bought it from.

Very disappointing.

Link to comment
Share on other sites

3 hours ago, Longbower said:

Would cost me more in Diesel than refund.    When I get time I will see whats stopping it from locating properly.

I might be able to re engineer it slightly.


I'd ring them up then post it back to them recorded delivery, and ask them to do the same?

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Create New...