Keith RW Posted April 25, 2022 Report Share Posted April 25, 2022 Evening all What options are out there regards aftermarket moderators such as the Hushpower detachable one, Quote Link to comment Share on other sites More sharing options...
Ultrastu Posted April 25, 2022 Report Share Posted April 25, 2022 The hushpower detachable is really good in my opinion . It's easy enough to fit with a couple of big spanners and will go onto barrels from 13 -- 16 mm you can slide it over the barrel as much or little as u want .it works really well depends on how hot the cartridge is of course . Choose a super quiet subsonic and it's like a mouse farting. A hot Italian cart and it's a bit louder . I find that the extra weight actually improves the balance of a slim single barreled .410 and you wind it off to put it away /clean . Get one . Quote Link to comment Share on other sites More sharing options...
steve_b_wales Posted April 25, 2022 Report Share Posted April 25, 2022 As above. I fitted a Hushpower to one of my 410 shotguns and it's very good. Quote Link to comment Share on other sites More sharing options...
Keith RW Posted April 29, 2022 Author Report Share Posted April 29, 2022 thanks for the replies guys, I presume the front bead needs removing to fit this Quote Link to comment Share on other sites More sharing options...
oldypigeonpopper Posted April 30, 2022 Report Share Posted April 30, 2022 12 hours ago, Keith RW said: thanks for the replies guys, I presume the front bead needs removing to fit this Hello, yes , what calibre are you looking at ? , They fit well on a single Baikal shotgun, the Kent RFD are very helpful Quote Link to comment Share on other sites More sharing options...
Keith RW Posted April 30, 2022 Author Report Share Posted April 30, 2022 12 hours ago, oldypigeonpopper said: Hello, yes , what calibre are you looking at ? , They fit well on a single Baikal shotgun, the Kent RFD are very helpful Looking for one for an old .410 folding Belgian hammer gun that I recently acquired Quote Link to comment Share on other sites More sharing options...
oldypigeonpopper Posted April 30, 2022 Report Share Posted April 30, 2022 (edited) 36 minutes ago, Keith RW said: Looking for one for an old .410 folding Belgian hammer gun that I recently acquired Hello, put a wanted ad on here and maybe on the airgun forum although there not to expensive to buy new, am still looking to fit the 12 bore one I have on my single BSA but it has a high rib so I might cut down to 25 inch barrel so the rib lines up better, there's roughly 4 inches to the internal baffles that will leave 6 inches of silencer on muzzle end so it should balance better , it's a full choke so with the 3 inch off should still leave a slight choke even cylinder should get a decent pattern with 5 shot carts I bought to use , don't forget its recommended fibre wad only as plastic might catch the baffles, cheers 👍 Edited April 30, 2022 by oldypigeonpopper Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.