Merlin64 Posted October 1, 2013 Report Share Posted October 1, 2013 I zeroed rifle in yesterday without the NS50 attached then fitted the NS50 and re zeroed again . It was shooting low about 2 mildots now . Rezeroed to the cross hairs and parallax was in focus etc . Any suggestions please ? Good news is I bagged 4 nice rabbits later. Quote Link to comment Share on other sites More sharing options...
zx10mike Posted October 1, 2013 Report Share Posted October 1, 2013 i can't see it having owt to do with ns50 as this just shows the image.perhaps the preasure used putting it on moved something?what rifle? Quote Link to comment Share on other sites More sharing options...
steve_b_wales Posted October 1, 2013 Report Share Posted October 1, 2013 i can't see it having owt to do with ns50 as this just shows the image.perhaps the preasure used putting it on moved something?what rifle? +1. Quote Link to comment Share on other sites More sharing options...
Dekers Posted October 1, 2013 Report Share Posted October 1, 2013 i can't see it having owt to do with ns50 as this just shows the image.perhaps the preasure used putting it on moved something?what rifle? +1. +2 Quote Link to comment Share on other sites More sharing options...
evo Posted October 1, 2013 Report Share Posted October 1, 2013 the ns50 would not adjust your Zero,, sounds like you have been a bit forceful putting it on your scope and whilst putting it on have actually moved the scope which has then had an effect on your zero, best advice is ,,BE GENTLE, don't force anything as the slightest knock will send your zero miles out, well done with the rabbits atb Evo Quote Link to comment Share on other sites More sharing options...
peek-at Posted October 2, 2013 Report Share Posted October 2, 2013 Ditto........ Quote Link to comment Share on other sites More sharing options...
Merlin64 Posted October 2, 2013 Author Report Share Posted October 2, 2013 Ok thanks for the comments Ill bear it in mind . Quote Link to comment Share on other sites More sharing options...
peek-at Posted October 3, 2013 Report Share Posted October 3, 2013 Check your mounts are nipped up tight Quote Link to comment Share on other sites More sharing options...
stubby Posted October 3, 2013 Report Share Posted October 3, 2013 (edited) ... Edited October 3, 2013 by stubby Quote Link to comment Share on other sites More sharing options...
Merlin64 Posted October 4, 2013 Author Report Share Posted October 4, 2013 Check your mounts are nipped up tight Spot on tip they were loose and needed a few turns . Must be the vibration makes them loose . Thanks again, Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.