remsie Posted December 29, 2017 Report Share Posted December 29, 2017 Hi all Anyone here know how to remove the bolt and pin assembly on a Falcon FN8 multishot. Accidentally recocked and pushed a second pellet part-way into the breach. I could remove it using a long M3 or M4 screw if I knew how the take the cocking lever off and the loading pin. Can this be done without depressurizing the cylinder? Thanks Quote Link to comment Share on other sites More sharing options...
Mr.C Posted December 29, 2017 Report Share Posted December 29, 2017 Think I might be tempted to try tapping it/them back out with a wood or plastic dowel first. Quote Link to comment Share on other sites More sharing options...
Fisheruk Posted December 29, 2017 Report Share Posted December 29, 2017 Just try firing it, it should discharge both, but not very accurately. Quote Link to comment Share on other sites More sharing options...
bruno22rf Posted December 29, 2017 Report Share Posted December 29, 2017 (edited) Is there no local gun dealer nearby? A quick prod with a cleaning rod would be the safest way to get them out. Don't put anything hard into the barrel and risk damaging the rifling. Edited December 29, 2017 by bruno22rf Quote Link to comment Share on other sites More sharing options...
silver pigeon69 Posted December 29, 2017 Report Share Posted December 29, 2017 Pm the PW member "FalconFN" if any one knows about FN's its him! Quote Link to comment Share on other sites More sharing options...
oldypigeonpopper Posted December 29, 2017 Report Share Posted December 29, 2017 hello, try to dry fire with bolt closed , or a wood dowel from muzzel end, i would give the breech seal a light oil spray if using dowel so not to damadge with pellet skirt in reverse, try LT1 pellet lube to, i had a FN as my first pcp and i had a few double charge, Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.