Woodbepigeonshooter Posted July 5, 2020 Report Share Posted July 5, 2020 Looking for some help! i was asked to have a look at an Original 35 which was missing a trigger unit., everything else looked in place. I ordered a new trigger unit and tried to fit it but the retaining pin is blocked from sliding through by a spring internally. The gun will break and slides freely but will not hold a cock without a trigger i’ M guessing. you tube has not helped just wondered whether you had any advice.or ideas to resolve Quote Link to comment Share on other sites More sharing options...
oldypigeonpopper Posted July 10, 2020 Report Share Posted July 10, 2020 Hello, try putting your reference on the 35, on the uk airgun forum as there are members who specialise in these air rifle, photos will help. Cheers Quote Link to comment Share on other sites More sharing options...
bruno22rf Posted July 10, 2020 Report Share Posted July 10, 2020 Check out the schematic drawing on chambers gun spares - make sure you have all the bits. Quote Link to comment Share on other sites More sharing options...
bottletopbill Posted July 10, 2020 Report Share Posted July 10, 2020 think you have to cock the the trigger unit as you put it in other wise it does not work. seen this on u tube. As i am not sure Quote Link to comment Share on other sites More sharing options...
snarepeg Posted July 12, 2020 Report Share Posted July 12, 2020 You may find you have to lift the spring to get your pin in, then the spring is under tension to work your trigger.? Quote Link to comment Share on other sites More sharing options...
Woodbepigeonshooter Posted July 13, 2020 Author Report Share Posted July 13, 2020 Thanks for the replies . you tube guidance in Spanish did the trick. the innards had been tinkered with and the part was upside down and also missing 3 ball bearings. The trigger wasn’t cocked when I fitted it and it was a bit fiddly but managed to get it all together even without a main spring clamp. (Pakistan YouTube guidance using body weight. Stock refinished in Boiled linseed oil and all back together working.... surprised myself! Quote Link to comment Share on other sites More sharing options...
oldypigeonpopper Posted July 13, 2020 Report Share Posted July 13, 2020 29 minutes ago, Woodbepigeonshooter said: Thanks for the replies . you tube guidance in Spanish did the trick. the innards had been tinkered with and the part was upside down and also missing 3 ball bearings. The trigger wasn’t cocked when I fitted it and it was a bit fiddly but managed to get it all together even without a main spring clamp. (Pakistan YouTube guidance using body weight. Stock refinished in Boiled linseed oil and all back together working.... surprised myself! 👍 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.