samboy Posted January 28, 2022 Report Share Posted January 28, 2022 Hi gang. I have a Browning 525 Trap gun that i want to take off and put a thinner one on but i cant find any holes in the pad that is on the stock. Any ideas ?. Thanks all. Quote Link to comment Share on other sites More sharing options...
scarecrow243 Posted January 28, 2022 Report Share Posted January 28, 2022 they will be there very fine hole in the rubber Quote Link to comment Share on other sites More sharing options...
Gordon R Posted January 28, 2022 Report Share Posted January 28, 2022 (edited) The holes will be there. Just stick a phillips screwdriver into the tiny hole and wiggle it about. Easy enough to locate the screw. Edited January 28, 2022 by Gordon R Quote Link to comment Share on other sites More sharing options...
Tonka54 Posted January 28, 2022 Report Share Posted January 28, 2022 Yes as above, they are just little slits that close back up after the screw heads have cleared, just feel around with a screwdriver and you will find them. Quote Link to comment Share on other sites More sharing options...
samboy Posted January 28, 2022 Author Report Share Posted January 28, 2022 Ok thanks. Will have another look tomorrow. Quote Link to comment Share on other sites More sharing options...
miki Posted January 28, 2022 Report Share Posted January 28, 2022 A dab of oil on the screwdriver helps it slide through the rubber ..... Quote Link to comment Share on other sites More sharing options...
TIGHTCHOKE Posted January 28, 2022 Report Share Posted January 28, 2022 Better off using a little spit! Quote Link to comment Share on other sites More sharing options...
samboy Posted January 29, 2022 Author Report Share Posted January 29, 2022 Found them. Thanks all. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.