Dibble Posted September 30, 2019 Report Share Posted September 30, 2019 (edited) This is a just out of interest question! I had a go at checking my shot pattern by putting up some big cardboard boxes, I could only go out to 20 meters. The result was much as expected the pattern was about 100mm low what surprised me was the wad had enough energy to go through two sheets of card. At least I presume thats what the large hole was. Going by the marks around the hole there was some shot embedded in it. The holes were 300mm to the left, 200mm low, with a mild crosswind going that way. I fired 12 shots and had 11 big holes in various bits of card. I had always presumed Wads fell away after 10 meters or so. Hull CompX fibre wad 7 1/2 shot 21g. AYA no3 with very little choke 1/4 and 1/2 ish. Edited September 30, 2019 by Dibble Quote Link to comment Share on other sites More sharing options...
wymberley Posted September 30, 2019 Report Share Posted September 30, 2019 Nothing unusual about the wads - I've had them puncture cardboard at 40 yards. Pay no attentioon to where they struck - they have the BC of a brick but even more erratic. A pattern centered 100mm low at 20m needs looking at perhaps though. Quote Link to comment Share on other sites More sharing options...
figgy Posted September 30, 2019 Report Share Posted September 30, 2019 Forget the pattern and start shooting things with the wads, if you get get some pellets stuck in the wad it increases the range. Seriously the range of the wad depends on loads and makes of carts. The thickness and material make up and density all factor in. Quote Link to comment Share on other sites More sharing options...
wymberley Posted September 30, 2019 Report Share Posted September 30, 2019 1 hour ago, figgy said: Forget the pattern and start shooting things with the wads, if you get get some pellets stuck in the wad it increases the range. Seriously the range of the wad depends on loads and makes of carts. The thickness and material make up and density all factor in. By gum, I think you've cracked it! Over the top of an obturator you load a mix of shot embedded in a mass of photo degradable wadding material which disintergrates within 0.2 secs from leaving the barrel. This delayed pellet spread would give us a 90 yard pheasant. Hang on, though, haven't we been here before? Quote Link to comment Share on other sites More sharing options...
figgy Posted September 30, 2019 Report Share Posted September 30, 2019 Ha ha wymberly if you market it I want a cut. Quote Link to comment Share on other sites More sharing options...
Dibble Posted September 30, 2019 Author Report Share Posted September 30, 2019 Did The Home Guard try pouring melted wax onto pellets so they would go through the choke but stay bunched longer? Of course what you really want for those long pheasant is something explosive with a proximity fuse. I work with a guy who developed Sea Wolf I'll have a word (I don't think Sea Wolf had a proximity fuse). Quote Link to comment Share on other sites More sharing options...
Walker570 Posted September 30, 2019 Report Share Posted September 30, 2019 (edited) 20yrds is much too close to do a pattern test anyway. At least 30 to 35 in my view as that is the working range so to speak. I had two pheasants last year given me after a shoot for using in a game pie. Both serious battered and one had a very large hole right through, obviously from a wad. Someone was stupidly shooting at birds far too close. It is likely shooting low because you are aiming, looking down the flat of the rib, which is not what you would likely be doing in a live situation. Try mounting the gun and firing as soon as you think you are on target and don't AIM like a rifle. For live game you would be or should be looking at the bird anyway. Edited September 30, 2019 by Walker570 Quote Link to comment Share on other sites More sharing options...
wymberley Posted September 30, 2019 Report Share Posted September 30, 2019 56 minutes ago, Walker570 said: 20yrds is much too close to do a pattern test anyway. At least 30 to 35 in my view as that is the working range so to speak. I had two pheasants last year given me after a shoot for using in a game pie. Both serious battered and one had a very large hole right through, obviously from a wad. Someone was stupidly shooting at birds far too close. It is likely shooting low because you are aiming, looking down the flat of the rib, which is not what you would likely be doing in a live situation. Try mounting the gun and firing as soon as you think you are on target and don't AIM like a rifle. For live game you would be or should be looking at the bird anyway. Two valid points. To amplify further: If you do a check at 20 yards and note the result, don't be too surprised if doing it again at the more usual 40 yards (where it probably matters more) you find that you've gone a full degree of choke more open. Yep, there's nothing wrong with aiming purely for a pattern test, but it's no good if you're looking at gun fit. However, even if you did aim at 20 metres, 100mm or so equates to double that at 40. To revert to good old Imperial, this would mean that just the top 7" of your 30" circle where the pellet count is going to be sparse - probably too sparse for a clean kill - is available to do the business. This is a considerable error and even taking that induced by aiming into account it's worth considering and having a look at it. Quote Link to comment Share on other sites More sharing options...
Vince Green Posted September 30, 2019 Report Share Posted September 30, 2019 (edited) 19 minutes ago, wymberley said: Two valid points. To amplify further: If you do a check at 20 yards and note the result, don't be too surprised if doing it again at the more usual 40 yards (where it probably matters more) you find that you've gone a full degree of choke more open. Yep, there's nothing wrong with aiming purely for a pattern test, but it's no good if you're looking at gun fit. However, even if you did aim at 20 metres, 100mm or so equates to double that at 40. To revert to good old Imperial, this would mean that just the top 7" of your 30" circle where the pellet count is going to be sparse - probably too sparse for a clean kill - is available to do the business. This is a considerable error and even taking that induced by aiming into account it's worth considering and having a look at it. Agreed Check pattern at 40yds, that's where lessons are there to be learned (holes etc) 20yds will tell you nothing unless its a .410 Edited September 30, 2019 by Vince Green Quote Link to comment Share on other sites More sharing options...
Walker570 Posted September 30, 2019 Report Share Posted September 30, 2019 I even check my 410 loads at 35yrds and also that gives me penetration results on the hard ply backing and penetration is important. No point in getting a good pattern if it doesn't get in there. Quote Link to comment Share on other sites More sharing options...
Old farrier Posted October 1, 2019 Report Share Posted October 1, 2019 And in 1900 and something they would have used paper cash and fibre wads 🙄 just wondering how many barrels have been burst or bulged doing this 😊😂 Quote Link to comment Share on other sites More sharing options...
dipper Posted October 1, 2019 Report Share Posted October 1, 2019 :Once saw a guy who was a well known shooter cut a shell and fire it in a Remington trap full choke.Most people there stood well back.Like old farrier said how many barrels have been ruined.Benthejocky you may not do this but a young person may just try it.And come unstuck.You could have issued a warning.We all know the stuff put on u tube . There’s always someone who will copy. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.